Key fob won’t work or program

Electronic systems, stereo and Holden iQ, wiring, it all goes here....
Post Reply
andrewquant
Posts: 18
Joined: Fri May 28, 2021 7:47 pm

Key fob won’t work or program

Post by andrewquant » Tue Jun 01, 2021 1:00 am

So I put a fresh battery in the fob. I checked the fob receiver under the rear deck carpet and it is getting 12v power (orange and black) but the fob still won’t function. I tried to program it on the DIC and I’ll hold the two buttons for >30 seconds but it never beeps to pair. What else should I check?
2013 PPV Phantom black (father son project car)
LS3 stroker 416ci, Lunati crank w/ Malhe pistons. 11.5:1
TSP Stage 3 cam w/ springs. BTR shaft rocker system
Kooks headers w/ Solo exhaust
Wideband O2 and HPtuners Pro (self tuned, WIP)
CDT Level 4 transmission rebuild and 3200 stall.
All done by my son and I, summer 2021

s/c'd cav
Posts: 1102
Joined: Mon May 30, 2016 8:12 am
Location: PHOENIX AZ

Re: Key fob won’t work or program

Post by s/c'd cav » Tue Jun 01, 2021 1:18 am

the RPOs for your car , its likely the agency either ordered it with them not functioning or had it disabled

coppcarz
Posts: 19
Joined: Tue Aug 10, 2021 8:15 am

Re: Key fob won’t work or program

Post by coppcarz » Sun Sep 05, 2021 10:10 am

I just purchased a '12 PPV from a municipal auction. My fobs don't work at all, and I replaced the batteries in both.

Which production code indicates that the car came with the remote fob functions disabled from the factory?

I also noticed that they removed a lot from the trunk, i may be possible that they removed the receiver assuming it was police equipment.

Does anyone have a photo of what a receiver properly mounted in the trunk looks like?

Thanks

Post Reply