New to the group and owner of an 2014 PPV

Welcome new members, please make your first post in this section. Say hello & tell us a little bit about you and your car. We're happy to see you here!
Forum rules
Welcome new members, please make your first post in this section. Say hello & tell us a little bit about you and your car. We're happy to see you here!
Post Reply
Mbibby
Posts: 6
Joined: Sun Jan 10, 2021 9:13 pm

New to the group and owner of an 2014 PPV

Post by Mbibby »

Hello to all and thanks for adding me to this group!
I just picked up an 2014 PPV from an auction this weekend.
45K miles/ 5,000 hours (3900 idle).

I asked on the Facebook group and wanted to post here what mods should I start with?
Ideally my center console...I prefer not to replace it totally since I do have two cup holders that came with it (in the rear of the console in between the seats) and a right elbow holder.
Attachments
AP0000052059-07.jpg
AP0000052059-07.jpg (125.49 KiB) Viewed 2376 times
IMG_0698.JPG
IMG_0698.JPG (237.92 KiB) Viewed 2376 times
Turbopowered68
Posts: 141
Joined: Wed Nov 04, 2020 7:09 pm

Re: New to the group and owner of an 2014 PPV

Post by Turbopowered68 »

Great looking car.
I made my own console - Kept the cop console base and also used the cup holders.
2014 Caprice V8
Elgin E-1840 P, LS9 Head gasket, LS7 Lifters, PAC-1218 springs, Trunion upgrade, Single roller timing set, Melling oil pump, ZL1 torque converter, Camaro Trans pan and filter.
1986 GN
212/212 Roller cam, 1.65 HR Rockers, 60-1 turbo, XFI 2.05, E85, Ebay Front mount IC, Husek Built TH200-4R trans, 3.42 gears 3800# .
1968 Chevelle
LQ4, 4L80, 12 bolt w/3.42 gears
Mbibby
Posts: 6
Joined: Sun Jan 10, 2021 9:13 pm

Re: New to the group and owner of an 2014 PPV

Post by Mbibby »

Thanks, I plan to do the same for the center console. Any tips on what you did are appreciated.
Post Reply