Page 1 of 1

Anybody running Pedders suspension?

Posted: Fri Apr 30, 2021 12:54 pm
by JTRUCKJMC
Looking to see how anyone who has installed Pedders XA Extreme (160064) struts and coilovers likes them. Looking to upgrade my 2013 PPV. Is it worth it, is it good for daily rides. I like the fact it is height adjustable and tuneable. THX ahead of time for any input.

Re: Anybody running Pedders suspension?

Posted: Tue Jun 22, 2021 7:17 pm
by Capeasy
Yes I did all the way around on my 13. I can't really notice much improvement since my old struts rode so bad lol. The new set up has some good adjustment, but still rides like a go kart.

Re: Anybody running Pedders suspension?

Posted: Wed Jun 23, 2021 12:07 pm
by JTRUCKJMC
THX Capeasy, was it worth the $, maybe I should just put some slight lower springs on the stock struts....

Re: Anybody running Pedders suspension?

Posted: Thu Jun 24, 2021 2:41 am
by Capeasy
Your welcome. Well my OEM struts had almost 90K on them and probably pretty worn. So the Pedders were a better replacement over stock, mainly because I could adjust the ride height of the car precisely where I wanted it to sit. And the struts have rebound adjustment as well. IMO I would recommend the investment.

Re: Anybody running Pedders suspension?

Posted: Thu Jun 24, 2021 9:28 am
by JTRUCKJMC
Thanks again, Great info, you answered my curiosity about using the Pedders setup. I have looked at about 5 other brands but like you say, this you can dial in ride height and adjust dampening. Other systems may lack one or the other, and then there is the mix and match strut/ spring combos that cost a little less but not much, so for around a grand you are good to go. I like like the ride height you set and was wanting about the same. By the way your ride looks great, thanks again.

Re: Anybody running Pedders suspension?

Posted: Tue Jun 29, 2021 1:50 am
by Capeasy
Yeah it's a bit on the low side so I had to fab up some "scrape rails" out of 1" square tubing about 3ft. Long bolted to the frame section of the body to keep the parking lot speed bumps from ripping off my cut-outs lol.