So i bought jba catless pipes for a few reasons,
1) a laugh at the rpm act
2) louder, and it is at idle
3) g8 board said itll lower my ET....
Drove it 55 miles there with catted pipes on. Let the car cool off for 75 minutes to start my 1st of 3 runs with a 40 minute break after after each, averaged 13.32
Took an hr to switch to catless b.c i had to clamp them to fit the x pipe. Ran 3 more with 40 in between each run... averaged 13.30 lololol
cars full bolt on, no engine tune - just cat sensor delete in the settings
Cats vs catless track results
-
- Posts: 141
- Joined: Wed Nov 04, 2020 7:09 pm
Re: Cats vs catless track results
damn between the weight savings and flow. I would have thought it worth a little more.
2014 Caprice V8
Elgin E-1840 P, LS9 Head gasket, LS7 Lifters, PAC-1218 springs, Trunion upgrade, Single roller timing set, Melling oil pump, ZL1 torque converter, Camaro Trans pan and filter.
1986 GN
212/212 Roller cam, 1.65 HR Rockers, 60-1 turbo, XFI 2.05, E85, Ebay Front mount IC, Husek Built TH200-4R trans, 3.42 gears 3800# .
1968 Chevelle
LQ4, 4L80, 12 bolt w/3.42 gears
Elgin E-1840 P, LS9 Head gasket, LS7 Lifters, PAC-1218 springs, Trunion upgrade, Single roller timing set, Melling oil pump, ZL1 torque converter, Camaro Trans pan and filter.
1986 GN
212/212 Roller cam, 1.65 HR Rockers, 60-1 turbo, XFI 2.05, E85, Ebay Front mount IC, Husek Built TH200-4R trans, 3.42 gears 3800# .
1968 Chevelle
LQ4, 4L80, 12 bolt w/3.42 gears
-
- Posts: 47
- Joined: Fri Sep 18, 2020 6:41 pm
- Location: Georgetown, TX
Re: Cats vs catless track results
I mean there are plenty of factory 500+ HP cars that have full emissions equipment, I think the common theory that cats are "too restrictive" is just a myth. And the exhaust smells better too.
2015 Caprice 6.0