Middle East cluster programming?

Electronic systems, stereo and Holden iQ, wiring, it all goes here....
User avatar
Mooseman
Posts: 1075
Joined: Mon Jun 12, 2017 11:35 pm
Location: Ottawa, ON Canada
Contact:

Middle East cluster programming?

Post by Mooseman »

So now that I have tap shift, it's now become annoying that I can't see which gear I'm in as the cluster doesn't display it because it was originally a 9c1. Looking through available calibrations available from ACDelco's online TDS for a possible 9c3 version, I have only found US/Canada and Middle East available. I could try loading that calibration into my cluster however I'm afraid to brick it and parts here for the Caprice are as rare as hen's teeth and I'd lose my original cluster and recorded mileage. And I don't know what kind of functionality I would get or lose with it.

Anybody have any insight or ideas before I even try this?
2011 Caprice PPV, former RCMP test vehicle, never put into service
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
119C3NJ
Posts: 74
Joined: Thu Feb 07, 2019 4:53 pm
Location: New Jersey exit 120 GSP

Re: Middle East cluster programming?

Post by 119C3NJ »

MY 2011 9C3 SHOWS THE GEAR IN SPORT AND MANUAL MODE. LSXTREME SELLS HOLDEN AND HSV CLUSTERS THAT ACT THE SAME WAY.
2011 9C3 Caprice PPV Phantom Black
1995 MG5 Yukon GT Black
1993 Harley Davidson FLSTC Black
Pursuit
Administration Staff
Posts: 969
Joined: Tue Apr 23, 2013 3:39 pm
Location: Omaha, NE area

Re: Middle East cluster programming?

Post by Pursuit »

Swapping out a cluster will red flag as odometer tampering. Can Chris White at WAMS help you out?

Regards,

Maurice
Maurice Sheil

mhsheil@gmail.com

2011 Caprice Phantom Black 9C3
2012 Impala 9C1
1995 9C1 Caprice
1996 GMC Sierra C1500
1996 Chevrolet K2500 Extended Cab, long box, 454, 91,000 rust free miles
1974 SJ Grand Prix 455 well optioned with factory moon roof
User avatar
Mooseman
Posts: 1075
Joined: Mon Jun 12, 2017 11:35 pm
Location: Ottawa, ON Canada
Contact:

Re: Middle East cluster programming?

Post by Mooseman »

Chris might be able to do it but shipping between Canada and US has been as slow as the Pony Express and Chris ain't cheap!

I couldn't find a 9c3 specific option unless it's a setup question it might ask before actually doing the programming. If I had a spare cluster I would experiment with it but again, none available here.
2011 Caprice PPV, former RCMP test vehicle, never put into service
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
smwalker
Administration Staff
Posts: 2201
Joined: Mon Jul 29, 2013 1:44 am
Location: Azusa,CA

Re: Middle East cluster programming?

Post by smwalker »

Does it show the calibration part number on the programming system?
IF you could list the options you have maybe we can look at out part numbers in engineering mode and see what matches?
Steve Walker
Azusa, CA
'11 PPV 9C3 Huron White
User avatar
Mooseman
Posts: 1075
Joined: Mon Jun 12, 2017 11:35 pm
Location: Ottawa, ON Canada
Contact:

Re: Middle East cluster programming?

Post by Mooseman »

I just looked at TIS/TDS again and I missed there is also an option for configuration and setup. I'm going to have to renew my subscription to TDS and see if I can change the configuration on my cluster.

I've been poking around here for programming info. Older vehicles would show all the software versions that were available and the changes. For these vehicles, not so much. I'll have to poke around some more. Will be interesting to see what's available.
2011 Caprice PPV, former RCMP test vehicle, never put into service
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
dkg
Posts: 8
Joined: Fri Aug 14, 2020 12:18 pm

Re: Middle East cluster programming?

Post by dkg »

This is interesting. You would almost definitely lose the trap speed setting and certified message but having a gear display sounds like a fair trade to me. When I put the vin from my 2011 in to TIS I get 3 options- programming, config and setup, and odometer programming. The first two have further options for middle East and "other", the only option under odometer programming is "USA and Canada police cars". Is yours the same?
Pursuit
Administration Staff
Posts: 969
Joined: Tue Apr 23, 2013 3:39 pm
Location: Omaha, NE area

Re: Middle East cluster programming?

Post by Pursuit »

On my 9C3, the Trap Speed, Certified Speedometer, Sport Mode, Manual Mode displays are all functional. I would imagine they all could be added and/or retained.

Maurice
Maurice Sheil

mhsheil@gmail.com

2011 Caprice Phantom Black 9C3
2012 Impala 9C1
1995 9C1 Caprice
1996 GMC Sierra C1500
1996 Chevrolet K2500 Extended Cab, long box, 454, 91,000 rust free miles
1974 SJ Grand Prix 455 well optioned with factory moon roof
User avatar
Mooseman
Posts: 1075
Joined: Mon Jun 12, 2017 11:35 pm
Location: Ottawa, ON Canada
Contact:

Re: Middle East cluster programming?

Post by Mooseman »

Sorry, been busy. Haven't looked into this much.

The odometer programming usually only works on brand new clusters. Well, that's my experience on trucks.

I wouldn't mind losing trap speed and the certified message, just as long as the cluster doesn't display in Arabic :lol:

I'll update once I get some time to work on this.
2011 Caprice PPV, former RCMP test vehicle, never put into service
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
LSX1105
Posts: 1
Joined: Sat Mar 12, 2022 12:45 am

Re: Middle East cluster programming?

Post by LSX1105 »

did you ever figure this out? im wanting to do the same thing and i have gm sps2 also
Post Reply