Radio and wiring part numbers and information

Electronic systems, stereo and Holden iQ, wiring, it all goes here....
RWT946
Posts: 4
Joined: Sun Oct 27, 2013 9:22 pm

Re: Radio and wiring part numbers and information

Post by RWT946 » Mon Oct 28, 2013 8:59 pm

Ok, very nice. Please keep me updated. Also, what does it entail to get the rear input activated? Flashing at the dealer?

User avatar
Tom Slick
Posts: 559
Joined: Thu Mar 21, 2013 10:27 pm
Location: Midlothian, TX
Contact:

Re: Radio and wiring part numbers and information

Post by Tom Slick » Mon Oct 28, 2013 11:21 pm

You can call it flashing... when they connect through the MDI, they can select options... like RSE (rear seat entertainment), Rear-view camera, etc...

Unfortunately, they can get Remote start to work on ones that didn't already have it...

Thanks,
Tom
1932 Glassic Ford Model A Roadster Replica - Ford 302/C4, approx. 1400lb... :-)
2015 GMC Sierra SLE Extended Cab - 5.3L

RWT946
Posts: 4
Joined: Sun Oct 27, 2013 9:22 pm

Re: Radio and wiring part numbers and information

Post by RWT946 » Mon Oct 28, 2013 11:38 pm

Tom Slick wrote:You can call it flashing... when they connect through the MDI, they can select options... like RSE (rear seat entertainment), Rear-view camera, etc...

Unfortunately, they can get Remote start to work on ones that didn't already have it...

Thanks,
Tom
I assume you meant "can't get remote start to work"?

I'll have to check with my dealer then about activating it. So hypothetically, in order to have the rear entertainment input activated, I would have the dealer activated it, then I would just need to make a wire to plug into the port you referenced on the side of the unit? Is that all?

Twotonfun
Posts: 30
Joined: Sun Nov 17, 2013 4:34 pm

Re: Radio and wiring part numbers and information

Post by Twotonfun » Sun Nov 24, 2013 2:15 am

It has been about a month since the last post. Has any one actually had any success in doing this modification?

Andy

User avatar
Tom Slick
Posts: 559
Joined: Thu Mar 21, 2013 10:27 pm
Location: Midlothian, TX
Contact:

Re: Radio and wiring part numbers and information

Post by Tom Slick » Sun Nov 24, 2013 11:28 pm

Yep, I have RSE and rear view camera enabled.

Later,
Tom Slick
1932 Glassic Ford Model A Roadster Replica - Ford 302/C4, approx. 1400lb... :-)
2015 GMC Sierra SLE Extended Cab - 5.3L

Twotonfun
Posts: 30
Joined: Sun Nov 17, 2013 4:34 pm

Re: Radio and wiring part numbers and information

Post by Twotonfun » Mon Nov 25, 2013 12:42 am

Tom

A couple of questions if I may..

Can the radio be wired for a stereo aux input so my Sirius Radio could be used?

Would purchasing the Radio Harness from a G8 help with having the connectors for adaption of other funcions like the back up camera?

Approx how long would you estimate that it takes to pull the head unit attach the harnesses and put it back together?

Thanks in advance

Andy

User avatar
Tom Slick
Posts: 559
Joined: Thu Mar 21, 2013 10:27 pm
Location: Midlothian, TX
Contact:

Re: Radio and wiring part numbers and information

Post by Tom Slick » Mon Nov 25, 2013 1:23 am

Our connectors are one piece versions... you just have to add the contactors for the audio... so yes, you can... at least through the RSE audio... as far as front auxiliary goes, I haven't had the opportunity to test it out...

as far as video goes... you'll need a video connector... the port is covered by a white label... I have a few of the video connector components... it has to be "built"... check out my thread on video connector...

I haven't had the opportunity to add the additional audio contactors, but I have installed the video connector.

Later,
Tom Slick
1932 Glassic Ford Model A Roadster Replica - Ford 302/C4, approx. 1400lb... :-)
2015 GMC Sierra SLE Extended Cab - 5.3L

BlackGT5
Posts: 64
Joined: Tue Dec 31, 2013 6:46 pm
Location: Metro Detroit

Re: Radio and wiring part numbers and information

Post by BlackGT5 » Wed Jan 01, 2014 11:36 pm

Tom Slick wrote:Everyone,

I found the following information out the last time I was at my local Chevy dealership:

Radio - 1st design - 92262691(dealership) or 92255301(online) (all 2011 and early 2012, including mine)
Radio - 2nd design - 92265524 (dealership)

Control Panel - Radio/HVAC - 1st design - 92257981 (all 2011 and early 2012, including mine)
Control Panel - Radio/HVAC - 2nd design - 92268061

HARNESS,COMMUNICATION INTERFACE MDL WRG. HARNESS-MICROPHONE, Mobile Telephone Radio. - 92247567
For: EK19 (2011-2012) (2011 - 2012). Required: 01

Anyone else done any research on these?

Thanks,
Tom Slick
Tom, do you know what the differences are between 1st and 2nd designs?

-George
2009.5 PBM G8 GT - CAI, Headers, Tune

User avatar
Tom Slick
Posts: 559
Joined: Thu Mar 21, 2013 10:27 pm
Location: Midlothian, TX
Contact:

Re: Radio and wiring part numbers and information

Post by Tom Slick » Thu Jan 02, 2014 2:07 am

No, I don't.

Most likely it's some small revisions to improve "stability"... guessing it has more to do with the control panel interfacing the unit, since they had a new part number for both the panel and unit.

Just to be safe, try to get a later version if you can...

Later,
Tom Slick
1932 Glassic Ford Model A Roadster Replica - Ford 302/C4, approx. 1400lb... :-)
2015 GMC Sierra SLE Extended Cab - 5.3L

BlackGT5
Posts: 64
Joined: Tue Dec 31, 2013 6:46 pm
Location: Metro Detroit

Re: Radio and wiring part numbers and information

Post by BlackGT5 » Thu Jan 02, 2014 2:31 am

Tom Slick wrote:No, I don't.

Most likely it's some small revisions to improve "stability"... guessing it has more to do with the control panel interfacing the unit, since they had a new part number for both the panel and unit.

Just to be safe, try to get a later version if you can...

Later,
Tom Slick
I have a 2nd design arriving on Monday. Will take some pics. Looking at online parts catalogs, there are also different parts numbers for the top radio trim (where the vents are) depending on 1st and 2nd designs. So was thinking there was also a physical difference.

-George
2009.5 PBM G8 GT - CAI, Headers, Tune

Post Reply