Page 1 of 1
King Springs install
Posted: Tue May 16, 2017 10:49 pm
by Hzgray
Halfway done in replacing springs on all 4 corners. Took a couple hours to replace rear coils today. The rear dropped about an inch from stock after a quick drive. KHFL-150 front and KHRL-152 rear.
Re: King Springs install
Posted: Thu May 18, 2017 2:03 pm
by Hzgray
Re: King Springs install
Posted: Sat May 20, 2017 10:35 am
by Hzgray
Glad I decided to get the alignment. It was way out after the install. Car seemed to drive fine- go figure.
Re: King Springs install
Posted: Thu Jun 08, 2017 5:21 pm
by Hzgray
After settling a bit the fronts dropped another .5 inch for a total 1 inch drop and another .25 inch in the rears.
Re: King Springs install
Posted: Sat Jun 24, 2017 3:12 pm
by camrat68
What was the part number for the springs front and rear? I can figure out where to find them from that I'm sure. Just researching options.
Thanks,
Jim
Re: King Springs install
Posted: Sun Jun 25, 2017 12:40 am
by Hzgray
The part numbers are in the first post.
Re: King Springs install
Posted: Sun Jun 25, 2017 10:47 am
by Silversled
The height looks excellent and almost the perfect stance as it should come form the factory. While the Eibachs and the H&R (on my car) look lowered, this looks OEM.
Re: King Springs install
Posted: Sun Jun 25, 2017 1:45 pm
by camrat68
Sorry, I missed that. Thanks!
Jim