Kooks 2014 SS system install on 2012 9c1
Re: Kooks 2014 SS system install on 2012 9c1
The kooks end were ball style. I would see if Kooks has the female side with a 6" pipe on it.
Dave
Chatsworth Ca
2012 9c1 ported LSA kooks 1 7/8 long tubes rotofab cai 575rwhp 570 tq. best repeatable 1/4 mile 11.32
69 Roadrunner 383 A/G 4 sp. bench seat (for sale) no rust
30 model A pickup QMP 383
Built Ford tough with chevy stuff
71 GMC suburban 4X4
Chatsworth Ca
2012 9c1 ported LSA kooks 1 7/8 long tubes rotofab cai 575rwhp 570 tq. best repeatable 1/4 mile 11.32
69 Roadrunner 383 A/G 4 sp. bench seat (for sale) no rust
30 model A pickup QMP 383
Built Ford tough with chevy stuff
71 GMC suburban 4X4
-
- Posts: 2304
- Joined: Sat Feb 07, 2015 2:31 pm
- Location: Pearland, Texas
Re: Kooks 2014 SS system install on 2012 9c1
I meant basically bridge the gap with a band-style clamp. On second thought, though, it wouldn't seal very well. Maybe a short extension. Interesting to think about, though.
The headers have O2 bungs in them, right? It looks like they may, pointing straight up from the collector. What did you have to do with the tune afterward?
The headers have O2 bungs in them, right? It looks like they may, pointing straight up from the collector. What did you have to do with the tune afterward?
Gene Beaird,
Pearland, Texas
2012 Caprice 9C1
1992 B4C 1LE Camaro
2018 Tahoe PPV (her car)
1995 DGGM Impala SS
1985 Firebird - 310 LS1 C Prepared autocross car.
1980 Bluebird Wanderlodge
And some others
Do YOU have my SPID?
Pearland, Texas
2012 Caprice 9C1
1992 B4C 1LE Camaro
2018 Tahoe PPV (her car)
1995 DGGM Impala SS
1985 Firebird - 310 LS1 C Prepared autocross car.
1980 Bluebird Wanderlodge
And some others
Do YOU have my SPID?
Re: Kooks 2014 SS system install on 2012 9c1
Yes on the bungs. You'll have to extend the driver side O2 sensor wires about 7". I did it to the sensor rather than the engine harness. Since it reads in Mv, solder the connections instead of butt connectors.
with intake and headers I think it made 30 rwhp. I didn't play with the tune until I cammed it. With so little advance in the factory tune, it would surely benefit.
with intake and headers I think it made 30 rwhp. I didn't play with the tune until I cammed it. With so little advance in the factory tune, it would surely benefit.
Dave
Chatsworth Ca
2012 9c1 ported LSA kooks 1 7/8 long tubes rotofab cai 575rwhp 570 tq. best repeatable 1/4 mile 11.32
69 Roadrunner 383 A/G 4 sp. bench seat (for sale) no rust
30 model A pickup QMP 383
Built Ford tough with chevy stuff
71 GMC suburban 4X4
Chatsworth Ca
2012 9c1 ported LSA kooks 1 7/8 long tubes rotofab cai 575rwhp 570 tq. best repeatable 1/4 mile 11.32
69 Roadrunner 383 A/G 4 sp. bench seat (for sale) no rust
30 model A pickup QMP 383
Built Ford tough with chevy stuff
71 GMC suburban 4X4
-
- Posts: 2304
- Joined: Sat Feb 07, 2015 2:31 pm
- Location: Pearland, Texas
Re: Kooks 2014 SS system install on 2012 9c1
Thanks, Dave. It's good to know that I can probably install this, and still use the car to get back and forth to work, before being able to schedule a tune. Someone out there has to have some O2 harness extenders, I may try to look around to see if I can find any. If not, then I'll try to fab something up with my weatherpack connectors.
This is now starting to look like a viable alternative to paying shipping to get a kit from Australia.
This is now starting to look like a viable alternative to paying shipping to get a kit from Australia.
Gene Beaird,
Pearland, Texas
2012 Caprice 9C1
1992 B4C 1LE Camaro
2018 Tahoe PPV (her car)
1995 DGGM Impala SS
1985 Firebird - 310 LS1 C Prepared autocross car.
1980 Bluebird Wanderlodge
And some others
Do YOU have my SPID?
Pearland, Texas
2012 Caprice 9C1
1992 B4C 1LE Camaro
2018 Tahoe PPV (her car)
1995 DGGM Impala SS
1985 Firebird - 310 LS1 C Prepared autocross car.
1980 Bluebird Wanderlodge
And some others
Do YOU have my SPID?
Re: Kooks 2014 SS system install on 2012 9c1
Were you able to swap out the exhaust manifolds for headers without jacking up the engine or removing additional pieces/parts?
Thanks
Thanks
2011 9C1 6.0
RCR "Little Lunati" 219/223 .625/.625 112+0
Kooks headers, hi flow cats, Dynomax Super Turbos
Flex fuel tune
RCR "Little Lunati" 219/223 .625/.625 112+0
Kooks headers, hi flow cats, Dynomax Super Turbos
Flex fuel tune
Re: Kooks 2014 SS system install on 2012 9c1
Did you ever find some O2 harness extenders? I just ordered Kooks headers and exhaust.CrashTestDummy wrote:Thanks, Dave. It's good to know that I can probably install this, and still use the car to get back and forth to work, before being able to schedule a tune. Someone out there has to have some O2 harness extenders, I may try to look around to see if I can find any. If not, then I'll try to fab something up with my weatherpack connectors.
This is now starting to look like a viable alternative to paying shipping to get a kit from Australia.
-
- Posts: 2304
- Joined: Sat Feb 07, 2015 2:31 pm
- Location: Pearland, Texas
Re: Kooks 2014 SS system install on 2012 9c1
I did not. I actually haven't even looked. My stack of mods for this car is already pretty tall, and doesn't include any engine parts yet. The summer here has been stupid hot, and incredibly wet, so not a lot of shop time has occurred this year. This mod probably won't happen until next year, if then.
Gene Beaird,
Pearland, Texas
2012 Caprice 9C1
1992 B4C 1LE Camaro
2018 Tahoe PPV (her car)
1995 DGGM Impala SS
1985 Firebird - 310 LS1 C Prepared autocross car.
1980 Bluebird Wanderlodge
And some others
Do YOU have my SPID?
Pearland, Texas
2012 Caprice 9C1
1992 B4C 1LE Camaro
2018 Tahoe PPV (her car)
1995 DGGM Impala SS
1985 Firebird - 310 LS1 C Prepared autocross car.
1980 Bluebird Wanderlodge
And some others
Do YOU have my SPID?
Re: Kooks 2014 SS system install on 2012 9c1
I got mine on eBay.tiny53901 wrote:Did you ever find some O2 harness extenders? I just ordered Kooks headers and exhaust.CrashTestDummy wrote:Thanks, Dave. It's good to know that I can probably install this, and still use the car to get back and forth to work, before being able to schedule a tune. Someone out there has to have some O2 harness extenders, I may try to look around to see if I can find any. If not, then I'll try to fab something up with my weatherpack connectors.
This is now starting to look like a viable alternative to paying shipping to get a kit from Australia.
Search "ls2 o2 harness" make sure it's 4 pin square connector extension- male on one end female on the other
Only needs 1 for the drivers front sensor. 6" would ne enough. I got a 12" and made a loop on it
2011 9C1 6.0
RCR "Little Lunati" 219/223 .625/.625 112+0
Kooks headers, hi flow cats, Dynomax Super Turbos
Flex fuel tune
RCR "Little Lunati" 219/223 .625/.625 112+0
Kooks headers, hi flow cats, Dynomax Super Turbos
Flex fuel tune
-
- Posts: 270
- Joined: Fri Aug 12, 2016 7:13 am
- Location: Tampa, FL
Re: Kooks 2014 SS system install on 2012 9c1
For anyone interested in KOOKS LT and mid pipes, MarylandSpeed extended their Black Friday deals through this weekend. I chatted with them on their website and they gave me a deal that frankly I've never seen before so I pulled the trigger on a set.
2014 Chevrolet Caprice PPV
2014 Chevrolet Stingray Z51
2016 AMG C63
2015 BMW X5 iDrive 50i
2014 Chevrolet Stingray Z51
2016 AMG C63
2015 BMW X5 iDrive 50i
Re: Kooks 2014 SS system install on 2012 9c1
looks good... sounds good too