Another DOD delete question and problem
Re: Another DOD delete question and problem
tedwards0633 , which pump did they include in your kit?
2011 Caprice PPV, former RCMP test vehicle, never put into service
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
- tedwards0633
- Posts: 80
- Joined: Thu May 25, 2017 1:48 am
- Location: Milwaukee
Re: Another DOD delete question and problem
I don’t have the part number, but it was whatever they recommend, it was packaged. Here is my post.
https://www.newcaprice.com/forum/viewto ... 1&start=10
https://www.newcaprice.com/forum/viewto ... 1&start=10
Last edited by tedwards0633 on Mon Dec 17, 2018 7:25 pm, edited 1 time in total.
Re: Another DOD delete question and problem
Ah, that said it was a high volume Melling.
2011 Caprice PPV, former RCMP test vehicle, never put into service
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
Build Thread: http://www.newcaprice.com/forum/viewtopic.php?t=2419
-
- Posts: 5
- Joined: Thu Nov 08, 2018 12:29 am
Re: Another DOD delete question and problem
Ok so here's the skinny on the engine so far, I tore it down to plug the bypass valve in the oil pan firstly, then I ordered the rivits to block the DOD oil passages as well as a new melling 296 I think is the part number. I figured I'd pull a couple caps and have a look at bearings while I was under the car. This is when I found cylinders 1 and 2 rod bearings spun. Cylinder 1 spun inside the rod and overlapped about 2/3 and were welded together so pulled the rest of the engine out last night for a crank and rods. I'm thinking bearings, new stock crank and at least 2 new rods. Any thoughts? Thank you. Joe