Re: Sounds like a lifter failure...
Posted: Tue Oct 10, 2017 10:56 pm
well the block would be bare at the point of getting the lifter bore bored out , so any metal from the lifter would have long been cleaned out
The worldwide owner-to-owner online support system for the Chevrolet Caprice PPV
https://www.newcaprice.com/forum/
Time to start looking for a 6.2L take-out!!centex2013 wrote:Well, good news and bad news. The lifter came out today... the roller was sitting right there on the needing to be replaced cam. Unknown where the other pieces are. And that's not the worst part. When the lifter failed it totally screwed the lifter bore and knocked a chunk out of it. Anyone have a block sitting around they don't need?