New Caprice - Discussion forums

Thanks for the replies. I kind of figured it was going to be the entire cluster. The Engineering Mode test reaffirmed the gauge not working. I think my next step will be to get a used cluster and see if it looks like I will be able to get to the stepper motor to remove it. If it doesn't look feasibl...

Hi All I had a few questions about the dash gauges. My temp gauge quit working on the first drive of the year. The sensor works fine and is reading correctly just the gauge doesn't work, the gauge doesn't sweep during startup. I assume this gauge works over the can bus. Are the gauges in the dash in...

I would have tried swapping to see if the problem moves with the injector. I would also pull the valve cover and take a look at the rockers and springs. Make sure everything is in place an moving like it should.

Besides the Caprice pipes being too small they dont exactly line up to the Camaro mid pipes. What I did was get the Camaro cats since the stock caprice cats are a restriction. They bolt right up. After that the camaro mid pipe/resonator bolts right up. It needed extended 6 inches to let the rear mee...

PM sent

Exhaust is sold! Still have the crash bar.

Yes it is complete uncut and no more than just some light surface rust. The car only had about 60k on it when removed and has never seen salt. I can get pics tomorrow if you want.

Yes I still have the exhaust.

Welcome. This is a good place to get info from. I am just north of Pgh.

The crash bar is a Go Rhino brand not Setina.